FAIL (the browser should render some flash content, not this).

READ ALL INSTRUCTIONS BEFORE USE!

Installing candles:

  1. Position ceramic gas log in fireplace in an arrangement where candle tins will cradle out of sight between logs.
  2. Arrange the four candle tins at the rear and level with the ceramic log for the best visual of flames. Use the bendable edges of the tin to secure the candle fireplace logs.
  3. Zinc core flexible wick can be repositioned to adjust flame size.
  4. Ensure that the candle tins are not above the edge of the ceramic logs and are stable without being tilted.

Lighting the candles:
   Use a long shaft Butane Lighter for lighting candles.

  1. After ensuring the candle tins are wedged in a level position
  2. Begin by lighting the tins at the rear of the log arrangement first.
  3. Light candle tins at the front of log arrangement last.
  4. DO NOT -- DO NOT TOUCH THE CANDLE TIN ONCE THE WICKS HAVE BEEN LIT.
  5. Four-hour burn time allows for reuse. Do not relight once candle tin reaches 1/4 inch of melted wax at the bottom. If wax burns all the way down and no wax is left there is great potential for fire hazard.

Snuffing out candles:
Candles will smoke temporarily after being Snuffed out!

  1. Best practice is to use a candle snuffer, especially due to the size of the candle wicks.
  2. Always snuff the candles at the front of the log set first before putting out those at the rear of the arrangement.
  3. ALLOW TO COOL AFTER SNUFFING OUT TO AVOID BURNS.
  4. Should a candle tin shift and spill wax or fall between logs Do not attempt to reposition

Approximate Burn Time: 4 hours

!SAFETY WARNINGS!
READ ALL SAFETY WARNINGS BEFORE USE
WARNINGS

  1. FOR USE ONLY IN LP OR NATURAL GAS FIREPLACES WITH GAS FIREPLACE LOG SETS. DO NOT USE OUTSIDE OF FIREPLACE.
  2. DO NOT ALLOW CHILDRE ACCESS TO FIREPLACE OR CANDLES TO AVOID INJURY.
  3. THE CANDLES MUST BE SNUFFED OUT AND NOT RE-LIT ONCE THEY REACH 1/4 INCH OF MELTED WAX AT THE BOTTOM. IF THE CANDLE BURNS ALL THE WAY DOWNAND NO WAX IS LEFT, THERE IS A GREAT POTENTION FOR FIRE HAZARD!
  4. DO NOT TOUCH THE CANDLE TIN ONCE THE WICKS HAVE BEEN LIT. ALLOW TO COOL AFTER SNUFFIONG OUT TO AVOID BURNS.
  5. SHOULD A CANDLE TIN SHIFT AND SPILL WAX OR FALL BETWEEN THE LOGS DO NOT ATTEMPT TO REPOSITION. WAIT UNTIL THE CANDLE TIN AND WAX HAS COOLED AND REMOVE FROM LOGS.

Click here to download these instructions